The roll holder is great, but the base requires gluing. There should be a dovetail or tabs to connect the base.

My only suggestion would be to add extra layers to the colors. you can get a little bleed through on lighter colors like pink.

Turned out pretty good

it really turned out pretty good. There are a couple of tweeks I will probably do for future prints.

A much better result with the improvements

I would recommend a brim to keep the edges from cupping.

It is a nice design, but it would be better if the front and rear finishers had some type of connector to oreint it for glueing.

I am really surprised how effective this is. I have gotten my TPU down to 7% humidity.

I especially like the funnel attachment.

It came out very nice. I would suggest printing with mouse ears or a brim to limit possible warping since the door is a little thin.

The new stronger design is much better

Went smoothly

I love it. I just wished there was an option for the sticker position on the plate to be open on the bottom half.

the walls under the threads are too thin. they need to be thickened for better durability.

Sent to my best friend as a surprise. He texted me immediately laughing.

I just wish there was an option to connect the 2. I use the hydrometer carrier to lay on the top of a spool in my filament dryer.

printed flawlessly, and my sister will love it!

it just barely fits the build plate of my P1S, so If I print again I'll use mouse ears since the corners pealed a little

I wish I had found this before I had printed 3 others that I was trying to modify with various levels of success.