worked great for running a Starlink cable from roof to router.

printed fine.

Huge improvement over the snap in versions that break. Thanks for this, perfect.

Design is cool, looks like my cat. Extruder spinner did not come out well and is loose, doesn't spin. A1, dry Jayo PLA, biqu cryogrip pro @ 35C.

These are much better than other, weaker ones out there. Fits different bill sizes just fine. thanks!

Printed great. a little awkward to use, but better than losing individual ones.

Printed ok, a couple of minor defects. Warped a little post printing even with a biqu cool plate @ 35C. Thanks for the modeling. Now displayed at Valve HQ. 😀

Printed a full plate just fine. They are too loose for generic type spools (Sunlu, Jayo, Kingroon, etc)

Printed fine. Don't think it needs so many fasteners for such low weight.. I used double sided tape. Thanks!

Easy peasy. thanks for the set up.

Printed great. Translucent PETG in lieu of gold. Black PLA didn't like adhering to that for the lettering, but that was my laziness in not changing it to black PETG. Thanks for the model!

printed and functions great.

printed at 80% scale in silk. Some of the supports were a PITA but they're cool.

Prnted at 85% in silk. That's too small for these joints but just throwing them into Easter eggs anyway. The lucky kid finds the paraplegic poop. They're cute. thanks!

printed and functions great, 8x on a plate.

Had no issues with any of the joints as others claimed. Well maintained and calibrated A1, Elego PETG all-up, no heat needed at all. Thanks for the fun print!

Turned out great, no issues. Elego PETG. Thanks for the fun project.

The knuckle joints were very hard to press on place for me. they seem to be mostly holding friction though. Probably going to try the single version again. 🙏

Printed great. Much better than a lot of the gravity gadgets out there. Didn't have to mod or file anything.