hudson s

squinn

A portable cable organizer which is setup as an easy print-in-place and includes a knob on the side for conveniently winding up the cable when you're ready to pack it away.<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/76375/2023-09-13_fd01d80e216de.gif"></figure>This model is an easy print that requires no supports, and three different sizes are provided to accommodate cables of different lengths. If you're not sure which to choose, I'd recommend starting with the “medium” size.&nbsp;After printing, you'll want to place the cable within the groove at its halfway point, close the lid (which is intentionally designed to close tightly), wind up the cord clockwise using the handle, and then extend by simply grabbing the cable by both ends.&nbsp;Update 2023-09-13:&nbsp;Alternative smooth-sided versions of all three sizes have now been added, and also the handle design was slightly adjusted to add a small fillet and chamfer to decrease the bridge distance. Here's a close-up picture of the updated handle on the knurled and smooth-sided versions:<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/76375/2023-09-13_e75ea621224d08.jpg"></figure><figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/76375/2023-09-13_68f2b35a6774b8.jpg"></figure>&nbsp;

Portable Cable Organizer / Winder

cool crap

JamesThePrinter

A selection of Halloween ghosts that use LED tea lights to glow.Short Models (100mm Tall)<ul><li>Scary Ghost</li><li>Spooky Ghost</li><li>Happy Ghost</li><li>Blank Ghost - Design your own face! (.f3d and .stl included)</li></ul>Large Models (150mm Tall)<ul><li>Scary Ghost</li><li>Spooky Ghost</li><li>Blank Ghost - Design your own face! (.f3d and .stl included)</li></ul><figure class="image image_resized image-style-align-center" style="width:50%;"><img src="https://makerworld.bblmw.com/makerworld/draft/70395/2023-09-12_nh65u2uq6cpe.gif"></figure>Most tea lights have a 38mm (1.5in) diameter. The openings in these models are slightly oversized, so most (if not all) tea lights will fit. Just turn on the LED and set your ghost on top. If you are worried about getting lights that fit, <a target="_blank" href="https://amzn.to/3YQGEA9" rel="nofollow noopener">these</a> are the tea lights that I used.&nbsp;Check out my other holiday models <a target="_blank" href="https://makerworld.com/en/u/1360890085/collections/23941" rel="nofollow noopener">here</a>.&nbsp;Print SettingsThese have all been designed to print with 2 perimeters and require no infill. Some overhangs in the mouth and eyes require good cooling.&nbsp;<a target="_blank" href="https://www.buymeacoffee.com/JamesThePrinter" rel="nofollow noopener">Buy Me A Coffee</a>&nbsp;The following filaments were used in the pictures above:<ul><li>Sunlu PLA White</li></ul>