Printed using PET-G and they came out great. My wife uses them to remove old wax from candle holders. Good for staking out garden lines, poking holes in garden fabric and if the mower finds lost ones, no problem. Versital tool…

Printed the single pass through in PETG with no issues. Works well for passing extension cord through the wall.

Printed these to go under candlestick holders to keep the wax of table cloth and other surfaces. Works great. Printed in PETG with no issues.

Printed this for a friend who likes dolphins. Spayed the back with adhesive and attached it to poster board so it could be hung in a frame.

Printed easy. Worked great for intended purpose until 5lbs(2.2kg) of potatoes were hung on it. 🤭Holds hats, light jackets and scarves.

I’ve printed out dozens of these for my wife and daughter. They say they work great.

Print looks great. Printed using solid and veragated filament. Adds a nice touch to the table.

Printed quickly. Used to hold up expandable curtain rods.

Printed in PLA. Quick, easy to assemble. The built in filament clips are handy.

Printed in PETG. Snug fit. I rounded off the leading edge to help slide in. They work great.

I did mine in PLA for a quick tempory need. Just needed to tap out three holes bolts at the bottom.

Printed great. Alittle larger than i needed but it keeps them from being crushed. i put a thin o-ring around top for waterproofing for fishing.

Turned out pretty good. My wife was happy with it. I started with the wrong color but was able to pause it and swap filaments. She likes the three colors.

Makes it easier to hold and see in the kit.

Came out great. Made a great Xhristmas ornament.

It came out great. Just a little sanding along the edges. Works as well as the original.