TPU case fits well, could use some chamfering or rounding on the edges, but grips quite well and isn’t too thick The additional parts (buttons and camera) have some issues that made this 4 stars. - the camera protector peels layer lines away very easily. I’ve had to reprint this part 2x in PETG and 1x in PLA. each time after just a day or two I start finding peeled off lines from the this part. I don’t drop my phone often and I think it wears quickly from going in my pocket. * could probably also use some rounding. - the buttons aren’t very secure, could fall out. the buttons don’t have a flare at the end, so leave the brim on! I’ve reprinted these already because the power button brim peeled, and I was able to pull the power button out without taking off the case. * should have a few layer thick flare on the inner part overall the best case I’ve found so far