harryduncan90

Prax 3D

A simple desk riser using a wood plank.depth = 18cm thickness = 2cmlength = anything yout want. &nbsp;I added some sqared holes at the bottom to fit some pad to avoid it being slippy.

Desk riser 

Functional

bigbearhouse

Bambu Lab AMS Holder/Stand for P1P to allow clearance when the Cable Chain Assembly has been added. This version is moveable and can sit anywhere along the top of the frame.At Bambu Lab, the AMS units are delivered in two different versions. One with 5 and one with 3 struts on the side. This version of the AMS holder should work with both versions. I have only tested with the 3 version.

Bambu Lab AMS Holder Stand for P1P with Cable Chain Assembly moveable.

Upgrades

BastelTube

Just a little tray for the Ikea Skadis board.Simple to print.&nbsp;Have fun

Ikea Skadis Tray

Skadis

davglass

This is a remix of the T-Rex Skull from MakerBot Academy, it's just setup to print on 4 plates and setup for the Bambu printers.&nbsp;Note: It's set to print without supports or a brim. It has been noted on the A model or if you use faster speeds you may need to enable a brim to keep the model from falling over. I have printed several without supports or a brim.

T Rex Skull with Base

Collectibles

Reckit

Made my own version of a P1S & P1P screen bezel based on @jogu44 version. I found the dimensions and bezel radius's to be slightly off. This one fits better (for me anyway)

Functional

Upgrades

Skadis

Collectibles

Tools