Hello fellow makers, I'm excited to share a project I've been working on: a wall mount for the Stihl AL charger (for the AP battery series). I don't know about you, but my garage was getting a little messy. My Stihl charger was just sort of hanging on a nail, half-supported, and it would occasionally fall to the floor. It was definitely time for a proper solution! Designing this mount was a fun challenge. I thought it would be a straightforward job, but it turns out there isn't a single 90-degree angle on that charger. It took quite a few prototypes to get the fit just right, but I'm really happy with the result. It's now securely mounted and looks much tidier. If you have a Stihl charger and are looking to tidy up your workspace, grab the model :-) I'd love to know what you think. Happy printing!