Really nice design, printed great. The click in place really sets this apart. Printed a bunch in two different colors so I had spots to show which batteries need charge (orange) and which are charged (green). Mounted so I could easily see the battery status. The top of the photo shows the empty state, bottom with all my batteries.

Nice model that prints well. It does seem like there is a double the number of filament switches then necessary as one of the colors was deeper than one layer.

Printed in ASA-CF with some elephant feet and it came out great.

Printed in ASA-CF. It came out great and went on with no problems which I was a bit worried about given the stiffness of the filament.

Great model and thanks to the designer for creating an extra deep version for my use case. I printed in ASA-CF which worked but for most use cases I would stick with PETG as I'm not sure how the hinge/latch would hold up to being opened/closed repeatably as ASA-CF is more brittle than PETG.