glengomezmeade

JamesThePrinter

This set is a great statement piece! Although not intended for actual use, they are sized properly to meet standards for an M64 nut and M64x150 bolt (ISO4032 &amp; ISO4762 respectively). I have also included the proper allen key (46mm) needed to install the bolt. The allen key has 3 main components, along with 2 pins to hold everything together:<ul><li>Section 1 - Tool End</li><li>Section 2 - Middle Piece</li><li>Section 3 - Ball End</li><li>Pin - Print twice</li></ul>Please see the assembly instructions below.&nbsp;Print SettingsAll pieces print fine without supports or any special settings. For best print results, print all pieces in the orientation as they come. Although not required, I reduced infill in most areas. However, I used a higher infill percentage below all top surfaces.&nbsp;Allen Key Assembly<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000216454/design/2024-03-02_xudrx1s15gg5.png"></figure>&nbsp;<a target="_blank" href="https://www.buymeacoffee.com/JamesThePrinter" rel="nofollow noopener">Buy Me A Coffee</a>&nbsp;The following filament was used in the pictures above:<ul><li>Bambu Lab Matte Charcoal PLA</li></ul>

Josie toys

office