I used petg, it printed great. IMHO this is the best holder for the A1 hub (I printed others trying to find the best and this one is best!

Printed perfectly!

Printed great in petg. All went together perfectly!

Appears to have weak points at the front. Mine broke on both sides during assembly but I glued them on and mounted, a couple of weeks later I printed and mounted a D3P riser for use instead. Otherwise this is a great model and would be greater if these end pieces were made more robust, IMHO.

This is awesome! Easy to print and easy to assemble once the auxiliary battery and extension cable arrived from Amazon

I modified this model so that it would hold a PolyMaker dryer by making the part shorter.

Broke mine and this is the replacement. It prints and works great! I broke the part that the cable guide attaches to. This model is hard to find in makerworld searches, it's a gem amongst the numerous derivatives which obscure finding this particular model.

Great print and looks great on my glass lid. I have the D3P riser for P1S setup.

The model only supports spools of a certain width. Wider spools sit "cock-eyed" on the model, in the cereal box. I would have to re-spool wide spools to a narrower spool for a perfect fit. Aside from that, your model is very good one and I thank you for uploading this model.

Great Improvement to a great design!!

Just what I was looking for! Printed very cleanly!

Prints and works GREAT!

2 type anchors in one. Printed perfect in ABS using 100.6 percent for shrinkage.

Glad I found this!! it prints and works flawlessly!