Search models, users, collections, and posts
Achievements
MakerWorld Guardian
This badge has expired
Share
0
0
0
hi everyone.
i have run into a problem.
which i hope you can help me with.
i have 2 rolls of original Bambu Lab Abs black filament. and every time i start a print, it makes a perfect Raft, but the first 2-3 layers of the item itself, becomes very bad, it curls up and becomes uneven.
ams has seen which filament is in it.
it is only the black filament that causes problems.
i have printed the same item with creality hyper ABS. And the item comes out perfect.
can anyone help me or has anyone had the same problem?
Share
0
0
0
fit perfectly, on an older rc4wd rim too,
however, had to adjust the beadlock ring in width so that there was room for the thumb steer on the rim.
Share
0
0
0
No more data