fredo626

Glock stand right handed remix

Printed to use with my 40ac dock and fit perfectly.  

I have a 65W ADLX65YLC2D usb-c power adapter that I used the 65w profile for and the fit was too tight, causing part of the model to break off.  I reprinted at 105% and there is a little bit of wiggle room.  Its a little tight getting the wire around the tab mount. If I had to do it again I would print at 104% for this power supply.

Printed in PLA using Bambu Matte Charcoal

Fabrion365

Thinkpad Universal Thunderbolt 4 Dock (40B0) mount

0.2mm layer, 3 walls, 15% infill

Printing in ABS I ended up with less refined edges but I'm sure that's a me problem since I'm new to this. Prints went well in PLA and saved a me a lot of space in my box. I printed all sizes but used mostly medium except the largest and smallest of sizes.  I'll probably go back and add a second holder to help keep everything lined up better.  Any suggestions on how to address the ABS issue are welcome.


Subierex

Modular Wrench Holders

0.2mm layer, 2 walls, 15% infill

Earn this badge when print successful more than 100 different models and 500 hours