I have a few battle scars from removing the supports but it was 100% worth it. This has to be one of my favorite prints. The hammer and trigger are super satisfying. I tried to replicate the Archangel variant from the game. I printed the barrel in two colors on a H2D and I changed the print profile a wee bit for: • increased detail: 0.16mm quality preset • silk filaments: 30 mm/s for extra glossy results • tree or no supports: as needed Some of the parts, mostly the ones printed in wood filament, were pretty snug so I had to use a trigger clamp to squeeze them into their proper place. Which was a little scary but I didn't break anything. (And this is to be expected with wood or other filled filaments.) Now I need to decide what to print next: either an upscaled Ol' Reliable variant or your Malorian 3516 model. Tough choices ahead. I included 2 very similar photos (#4 & #5) because they show how much different the silk filaments look with even slight changes in lighting.

Clean and crisp print. Thanks. Printed in beige PETG.

Came out perfect, thanks. Design is impeccable, highly recommend. Printed in ASA on CryoGrip Glacier plate. Which holds perfectly during printing but basically falls off the bed at ~70°.

Posted a rating with pictures for the funnel already, this is for the container. I am really impressed with all the models. Thanks.

Design is impeccable, highly recommend. I printed the fine mesh version for Bambu spools. It seems to fit v3 of the Sunlu replaceable spool as well. Printed in ASA on CryoGrip Glacier plate. Which holds perfectly during printing but basically falls off the bed at ~70°.

I made a double-stuff oreo. Printed in ASA on CryoGrip Glacier plate. Which holds perfectly during printing but basically falls off the bed at ~70°. Came out perfect, thanks.

Printed in Polymaker Natural ASA on CryoGrip Glacier plate. (Which holds perfectly during printing but basically falls off the bed at ~70°.) The print profile was for ABS with ABS-S support interface layer. I removed the ABS-S from the Project Filaments and reset all the related interface layer settings while keeping the main support settings. Printed like a treat. Supports peeled right off. Printing up next batch now.

Printed without issue. Thanks.

I had the CMYK set of filaments loaded so I ended up with cherry blossom stars. I shrunk it to 50% and deleted the support connectors between the bearings and it printed perfectly and spins for awhile.

great print, thanks

Printed in Black PETG HF from mobile app. Clean prints and will start assembling in a few minutes.

I haven’t assembled yet, but looking good so far. Printed in black PETG-HF and green translucent PETG.