I printed the shorter “A1 mini” model on my X1C, because I used the textured PEI build surface I added a few mouse ear brims in Bambu Studio, but didn’t change anything else. Printed in Matte Black PLA, and it works well and looks good. The metal mounting bracket blocks part of the cable hole so my Ubiquiti cable needed to be fed through first, but no big deal Really nice model for using low amount of filament and looking like it could have come with the WAP itself ❤️

Prints nicely

Works well

PETG as support interface worked perfectly for me

Printed in Bambu PC using the ASA profile (with brim, which came off beautifully) on smooth PEI. Parts are nice and assemble easily, yet have a bit of a tight fit which is perfect for making sure they won’t vibrate loose or anything. The only bummer for me is that a percentage of my alumina desiccant is too large for the funnel and gets stuck. However, with the funnel remove the opening is plenty large enough to fill (I put desiccant beads in a plastic bag and used the parts to scoop up the beads, not worrying about spillage because it is all happening in the bag) THANKS

Thanks, works a treat in PETG-HF

Works and looks great. Have printed multiple times thanks

Works great. Ised Bambu PLA Matte no problems

Works well, though I would advise printing the wheel chock portion on the side (with ironing turned up), or at least use thinner layers for a better round surface. Really nice for everything else though!

Fun to watch print and the result is exactly like the photos ❤️

Fun to watch it print and the result is exactly like the photos. Family are all stunned ❤️

Printed nicely, thanks. This does suffer from the same issue as my X1C where the feet fall out, so maybe I’ll check if the part I printed to stop that on my X1C works here as well (-8

Printed in PETG Basic, works great, thanks!

Printed another pair, this time in PETG Basic Lake Blue. Came out great. PETG is more flexible than PLA so getting the top on/off is easier but the main tray is probably just a bit too soft … I think I’ll stick to PLA in the future for the stiffness. Either way, fantastic little model and print profile

Great way to print samples, Two AMS at a time!

Work so well that I use more than I need because why not? Peonted in PETG

Nice model, printed well and supports really do come off easily. A couple the overhangs aren’t great even with the supports but they aren’t visible normally so not a problem. I really appreciate the detail and that the model prints at a nice lighter weight saving a bit of filament. Got lucky with the alignment of the 3 colors with Eryone Tricolor Silk PLA Green Purple Black