These printed perfectly and look great. I scaled them down to 19mm diameter, then designed these clips that hold the tokens on cards that slide into a Pokemon card box.

Fantastic print quality on the first try in PLA. The two halves fit tightly and slide smoothly. Supports are minimal and easy to remove.

Printed perfectly. I was a bit concerned when I saw the wide brim for the first layer, but it peeled off the part effortlessly. The hardest part was getting the brim off of my textured PEI. Time to print a better scraper!

Using it for an Amazon Fire tablet. I love how it locks at the angle you choose.

This printed fairly well, although some extra material was inside of the void and a bit difficult to remove. I bought a spool of ASA with the assumption that this high speed, high friction part would need it. But I printed it in basic PLA first as a test and I've been surprised and impressed with how it's holding up. I've used the blender on a few meals and the PLA hasn't cracked or warped! This is my favorite 3D print so far because we contacted Mueller who said they refuse to sell replacements for this piece. They do have replacements, but limited quantity that they are reserving for those who have a blender still under warranty.

This printed great and has been super useful. I didn't have the desk space for my AMS Lite and mounting it to my wall would have made it difficult to reach the rear 2 spools. I love how this pivots to reach them all more easily.

This printed well using Inland PLA Basic, but has hinge strength issues. One hinge snapped off as soon as I dry fitted the top and bottom together. The other snapped when I inserted the screw as gently as possible, even after sanding the inside first to make more room. I was able to salvage it with epoxy and avoid the many hours to reprint. I added a Pikachu logo and shared it as a print profile since the license prohibits remixes. I was surprised to realize the box is much too large for normal Pokemon cards. My fault for not realizing it is sized for cards with sleeves, which are much larger. Learning opportunities for myself: I should clean my bed to avoid the marks on bottom from the previous print. And I used ironing but it turned out mediocre. I should have tested ironing speed and flow settings on a smaller sample first to improve the finish.