ok appart from the back fins that did not print very well

The body of the helicopter prints well and is well balanced, removing the supports takes some time and is difficult in the area of the tail propeller. The rotor prints well too but the connexion with the body is way too loose, I had to print an additional cylinder to fill the gap.

prints perfectly in PLA with the supports included in the profile.

prints good, the connection with the plane is a bit too loose though.

Printed just fine in PLA matte. I merged it with a pulley from another model. The bearing turns quite smooth but the "pearls" themselves are not turning so I will trywith different filaments to see if i can get a tighter fit.

I love the cups so much and my kids wanted the tray to play waiters. The middle size fits 4 cups just right. The tray prints great but in PLA it is too slippery: the cups fall all the time. And the cute surface pattern is not ideal to clean up when the game gets messy....Nonetheless the whole set is super cute and makes a great gift! I added some "latte" insert from another model

The model is great and prints perfectly. It does not fit to my Smartfil spools but is perfect for my small spools.

I printed them in glow in the dark PLA and they printed perfectly. My only down note is that stacking is way too easy so it foes not keep my kids busy very long!

Quick, simple and direct to the point, no screws needed and perfect fit. Just what i was looking for!

Very cute model, a little fragile but so much fun

Prints perfectly. I like that it allows to keep the AMS shut unlike other solutions for spool with adapters, but I can't see the slots lights anymore and have a harder access to the filament charging push button. Great design nonetheless.

I was very skeptical about the print without support but it actually worked like a charm (with a brim). One of the lower corners did not print very clean but I'm sure it would be easy to correct by just opening the printer door. My kids love them! I would recommend to make the connection of the lid to the body stronger if intended as a toy for kids, but perfectly fine for other uses.

Prints very well. The surface of the stamp part was not very smooth in my case, maybe i should try with ironing. I tried to stamp with linoprint ink and it worked, I don't mind the distressed "vintage" effect. The stamp handle is not super comfortable to press down, maybe a flatter top shape would be better?

Perfect model. The little springs are a bit stiff at first but they get better with use. The lock works well.

Printed in PLA the screw is very tight. With a drop of oil it goes in though

It's thin but works just as intended

All perfect

Prints perfectly fine. A luxury print from the filament consumption point of view but a fine model. Note: the size is too small to fit a regular soap dispenser (Spanish size).

The print was easy and fast. I reduced it to 20mm thick. With the filament i used (Sakata Flex 920), it is quite stiff but will do for hard scrubbing. It (obviously) does not suck water like a regular sponge.

Incredible model! the print went super smooth and the fit and the anti-vibration effect are astounding. Printed in Sakata Flex 920.