New and great case for Wio Tracker L1 from Seeed Studio. It has been designed to increase the battery capacity, featuring a 3000 mAh battery, plus a pogo pin connector (optional) to expose the solar charging and grove ports of the unit. Also it was designed to be printer-friendly, you can print the back part of the case horizontal or vertical with only some supports.

Case for SenseCAP Indicator for Meshtastic has a Magsafe mount on the back of the unit. It also has a detachable back part by means of strong neodymium magnets to add some sensors and keep it as one unit. I am using it for GPS Air 530 via grove port and it is working great.

Best Skadis holder for Ugreen Nexode This holder for the Ugreen Nexode is space friendly for Ikea Skadis, holds it well, it rotates vertically so removing and putting the PowerBank back is a breeze, and also does not collide with other things that you put over it on the Skadis when you remove or put the PowerBank, thus saving space on your Skadis board. Prints with supports and uses T-Clip system.

Are you tired of Skadis transparent cases opening and falling? I am. This pieces avoid the cases to fall. You can use a 8x2mm magnet, double side tape, hot glue to keep them in the lid. I have shaken like crazy my Skadis board which is just fixed to the table and no vertical fixes and the pieces work great!

Charybdis mini wireless keyboard. Since the Charybdis mini is my favorite keyboard I really needed a way to carry it safely. I had in mind a very curvy and organic travel case that fitted the keyboard perfectly. More than 50 hours of design and lots of filament in prototypes were invested to get the final result. Each side is formed by two pieces that snap together perfectly with 6mm diameter and 3mm height magnets.