etreynolds07

Jaxel

2024-01-14: Increased the tolerances of the back plate by 0.4mm.2024-01-12: Changed the locking pins to have more strength and better alignment. This model is designed to work with my <a target="_blank" href="https://makerworld.com/en/models/78138#profileId-82402" rel="nofollow noopener">Wall Control Universal Mounting System</a>.It uses some parts from that package in addition to the STL models in this package.&nbsp;This will hold any generic Milwaukee Bit Holder Box. Connect the hangers and wings to each side of the back plate using biscuits and slot it into the pegboard. Once slotted, screw it down using the locking pins.&nbsp;Parts required:<ul><li>Milwaukee Bit Holder - Back Plate</li><li>Milwaukee Bit Holder - Left Hanger</li><li>Milwaukee Bit Holder - Right Hanger</li><li>Universal - Wing (2 slot) - Left</li><li>Universal - Wing (2 slot) - Right</li><li>Universal - Locking Pin (x2)</li><li>Universal - Biscuit (x8)</li></ul>You can find other models I have released for this mounting system here:<a target="_blank" href="https://makerworld.com/en/u/2811301167/collections/111107" rel="nofollow noopener">https://makerworld.com/en/u/2811301167/collections/111107</a>&nbsp;If you appreciate my models, please consider <a target="_blank" href="https://ko-fi.com/ultrajaxel" rel="nofollow noopener">buying me a coffee</a>!

Wall Control - Milwaukee Bit Holder Box

garage

asc_ii

This is a remix of the great design of <a href="https://www.printables.com/model/461345-bambu-poop-chute" rel="nofollow">Bambu Poop Chute</a> by <a href="https://www.printables.com/@KevinV_460266" rel="nofollow">Fantasy3DPrintsShop</a>Uses 6x3mm magnets to attach the chute to the back of the X1C, P1P or P1S case.No supports are required.I printed using these settings:<ul><li>0.4mm nozzle</li><li>2 layer wall</li><li>no support</li><li>10% infill</li><li>no brim</li><li>no supports</li><li>top surface only ironing</li><li>adaptive layer height (using the default adaptive layer bambu studio settings)</li></ul>Used 380g of filament and I was able to use ludacris mode after the base layers were printed to decrease the print time.6x3mm magnets are easily sourced from amazon, ebay or aliexpress. I used N45 grade which gives nice attachment strength.The magnets are a tight fit when pushing in. If it feels too tight, use a craft knife to gently scrape, sand or cut away the top of the hole to enlarge slightly. If you make too large - no problem just use a bit of super glue to hold the magnets in.

garage

upgrades