estiwardm

One Maker Show

This is a perfect replica of the Dovetail System by Microjig.Here two types of Track Nuts bots need to be used with <a href="https://amzn.to/43rBwUK" rel="nofollow">M5 Insert Brass Nuts </a>and two kinds of track screws: one for M5 Bolts and the other one to be used with <a href="https://amzn.to/3OXTvOk" rel="nofollow">M5 Insert Brass Nuts SHORT Version</a>

Dovetail Track Hardware Microjig Replica

Electronics

laisch

With this handy little tool you can clean your carbon rods even when the lid of your bambulab printer is closed.Just put Isopropyl alcohol on the sponges, snap it to your carbon rod and move it back and forth a few times till they are shiny again.<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/251911/2023-12-07_e4ey6ohuzxon.gif"></figure>&nbsp;<h3>Postprocessing</h3>For the sponges you can use a normal kitchen sponge (be careful to not use the abrasive ones). Cut two pieces roughly about 10x20x20mm and press them into the spongeholder.For the pullback mechanism you can either print the provided spring in TPU, or use small hair rubberbands. The spring also works in PETG but looses its strength from time to time.<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/251911/2023-12-07_g1k0c2tnzlwn.jpg"></figure>&nbsp;&nbsp;More info about cleaning the carbon rods can be found in the <a target="_blank" href="https://wiki.bambulab.com/en/general/carbon-rods-clearance" rel="nofollow noopener">Bambulab Wiki</a>

Electronics

3D Printer