Fits like a glove, thank you!

Worked perfect!

Perfect for a similar project of mine. I modified the front a bit as I only had the temp/humidity sensor, but other than that it was all good. Thank you!

I had to stop the outer shell print after a few layers and add some painted prims along the edges to avoid warping, but other than that it printed nicely. I could not get a 100% fit when putting it together and there is a 1-2mm gap in the bottom, but all in all a nice result.

Ended up with a nice result! Great work!

Looks very nice! Confirmed by several inhabitants in the house :) If there is one thing that maybe could be improved it's the fact that the separate piece does not slide down 100%, but may be solved with some sanding paper.

I was missing this on my car, and this model solved my problem :) Printed with PTEG and hopefully it will last long. Thank you!

I tried to print 3 pieces with 0.2mm nozzle and they did not come out as expected. I think it took to long for each layer so the corners warped in some areas. However - when I tried again using the 0.4mm nozzle it came out perfect, so not the models fault :)

It took some time, but the result was perfect! Printed with Panchroma Matte Cotton White.

Very nice result, thank you!

Fits my Makita battery perfect!

Works perfect 👍🏻