Works well! Takes a little bit of force to split apart, but no damage.

These always work magically.

Works perfectly to keep the door to my laundry room open, so that our cats can get in and out. Printed in two colours of PETG. No strength issues yet, and the print-in-place link works well.

Small version. Great model for spray-painting. Did a dark first coat, and then a light highlight coat from above.

Printed great. I also printed one scaled to 175mm height, for an outdoor garden.

Absolutely fantastic print, even with default profile supports. The one area where there were some imperfections/minor failures is the lowest part of the pot (second pic), but it's not nearly as bad as I'd expected and pretty hard to see with the pot sat down on a table. I was worried about some of the supports higher up on the model (third pic), but they're basically invisible in real life.