5 Starts for the effort, printed it as a gift for a friend. Had to remove the support from the Body Parts (Plate 1) since I could not get the support out from the holes. Also had to add a brim to the hinge rod because it would not stay flat (probably going to replace it with a steel rod anyway since that looks like a point of failure). Everything else was just hit print and go. Printed it all in Bambu PLA except the wings, I went for Glow in the Dark from Polyterra. Adding pics after assembly. Edit: Took lots of glue and had to take a break since i had too much glue on my fingers 😭