eliantcavazos

Little Mac Designs

A Spyglass for all of your pirate cosplay needs. This spyglass expands from 7 inches to 33 inches! If you're looking for an absurdly large spyglass, then this is the one for you!

33" Collapsible Spyglass

swords and stuff

NurotikPanda

This 4x4 Gridfinity device holder has sliding dividers to hold your drives, battery packs, mice, or whatever you want.&nbsp;There are 2 types of dividers, the regular one has a little more play while the tight divider is a tighter fit. Both types of dividers can be held in place with a 3x8mm screw. I've printed these in PLA with a 0.6 nozzle. The tight fit divider needs a little trimming if you have some elephant foot going on in the first layer, but it's just a little nip with some flush cutters. No supports are needed. &nbsp;Gridfinity is the ultimate organizer for your whole workshop! Learn more at Find more Gridfinity accessories at <a target="_blank" href="https://bit.ly/3E2NxnZ" rel="nofollow noopener">https://bit.ly/3E2NxnZ</a>

Gridfinity Device Holder

gridfinity

Saber3D

Check all my models out at <a target="_blank" href="https://saber-3d.com/" rel="nofollow noopener">www.Saber-3D.com</a> &nbsp;New dragons, creatures, and more released every month to my patrons, thank you for supporting my work! &nbsp;Follow our socials to see new models! <a target="_blank" href="https://www.instagram.com/saber.3d" rel="nofollow noopener">Instagram</a><a target="_blank" href="https://www.tiktok.com/@saber3d" rel="nofollow noopener">TikTok</a>&nbsp;This flexi dragon was designed to take less time but still give you the awesome look of a large dragon as well as make custom designs as easy as possible! Every part of this dragon can be easily painted in your slicer of choice, just make sure edge detection is turned off 😉&nbsp;Want to sell prints or just enjoy the instant access to all my models? join our All Access tier on <a target="_blank" href="https://www.patreon.com/Saber3D" rel="nofollow noopener">Patreon</a>. &nbsp;&nbsp;&nbsp;&nbsp;&nbsp;

Articulated Crystal Dragon by Saber3D

toys

cm3dshop.de

Poop Chute with Tray and hidden Handle&nbsp;Easy acess to the Poop with a pull out tray (if you got low space behind and besides the printer)&nbsp;stays in place with 5 round Magnets (attached to the printer) d=6mm ; thickness 4mm (3mm will also work when not pushed all the way in)&nbsp;tray can be hold closed with 4 magnets (Attention at the polarity!) …just optional&nbsp;hidden handle with Bambu Logo for pull out the tray : flat with front when closed ; for opening push the top part in and then pull at the lower part…very simple and easy…fully printed&nbsp;optional Lid for "clean design"&nbsp;&nbsp;Added a version for Users with a 40mm Stone plate under the printer.. So there is additional space for the Poop. ;)<a target="_blank" href="https://makerworld.com/en/models/79531#profileId-84152" rel="nofollow noopener">https://makerworld.com/en/models/79531#profileId-84152</a>&nbsp;At All it is a bit over engineered … but…does it really matter?! ;)&nbsp;Just let me know in comments when you have suggestions for improvement.&nbsp;ATTENTION: the print profile uses the PETG/PLA trick to get a super smooth interface between the Tray and the supports!&nbsp;&nbsp;

swords and stuff

gridfinity

toys

printer pieces