Search models, users, collections, and posts
Bio
..
Achievements
MakerWorld Guardian
This badge has expired
Share
0
0
0
outstanding print, perfect fit on first try, H2C and X1C
Share
0
0
0
I made these up from scratch in Fusion using the original 1983 toy for reference. They are roughly proportionately correct. Scale to fit your Ravage print, by default these fit Ravage printed at 210% of its original file size (making the cassette basically the max size for an H2C, around 7.5x11.5 give or take).
If anyone has been thinking about printing the Ravage v2, be aware it needs considerable work to make proper, I had to do hours of mods to it to make it print ready.
Proper missiles for Ravage Transformer model
6
19
Share
0
0
0
simple and stylish, just the right amount of contrast.
printed perfectly in ASA
Share
0
0
0
printed very nicely with nylon. supports were a little difficult in the eye holes and up the sides but not terrible (and it was nylon after all).
I did have as little bit of choppiness at the ear tops, and a false spaghetti detection when the top center supports were almost ready to layer, no big deal though just had to resume 😎
Share
0
0
0
printed perfectly. used Nylon and 0.6 nozzle, no issues.
Share
0
0
0
Share
0
0
0
nice, a little loose though, could use a few tenths tighter bridge as it slides around on it's own 😎
Share
0
0
0
Share
0
0
0
Share
0
0
0
Outstanding print. Far superior to other designs that seem anxious to tear at the sheet during retainer install. I did skip right to the larger sleeve for that reason, but printed both in case there's any slipping or something.
Printed in PETG with 0.6 nozzle.
Share
0
0
0
Share
0
0
0
nice easy print. extremely thin and attractive. my only complaint would be the recesses for rubber feet... while a great attention to detail... causes layer line banding around the project due to the speed change. otherwise top notch.
Share
0
0
0
this made a great extra screen/filter for my pc side air intakes. I switched to gyroid infill because gyroid is life. made a nice look to it. it's also just thin enough you can easily slice it to size with an exacto too.
thanks for this!
Share
0
0
0
outstanding. combined the caps to one plate otherwise printed as is. haven't done the gaskets yet but works great without them anyway.
Share
0
0
0
amazing. printed in asa-cf with zero issues. like printing fabric.
Share
0
0
0
very nice design. I tweaked mine some: I narrowed the pockets .2mm so that the inserts were more snug (might narrow them a little more though). I also shortened the overall height and dropped the pocket arcs lower so that the watches could be covered with a lid made to match.
even with a 12mm brim I still experienced shrinking on the far right corner like I did with the original but I haven't looked into it any further yet.
Share
0
0
0
unexpected find. very good likeness.
Share
0
0
0