Search models, users, collections, and posts
Bio
3D Printing is life 🙌
Achievements
MakerWorld Guardian
This badge has expired
#PrintClinic
My abs prints have ended up like this, with the top layer rough and movements squeky. I have an a1 mini but with an enclosure that circulates heat. Before the enclosure the abs wouldn't print at all and would only spegetti. I also dried the abs with a filament dryer before use but maybe not long enough 🤔 Could it be the filaments too wet, my enclosure doesn't work so it's nto hot enough, or i need to enable top surface ironing?
Share
0
4
0
It works as intended and holds my phone very well horizontally AND vertically even though it's a bigger-than-average phone. It was hard to find a phone stand that would be structurally strong and would hold both ways but thanks to this one I finally have.
Share
0
0
0
The arrow stays on the headband well but the whole thing itself kept slipping off my head. A solution I found was to put two-sided tape on the inside of the headband then attach it to a baseball cap.
Share
0
0
0
No more data