The model printed beautifuly on Bambulab Pla Matte, one of the best prints I had. Unfortunately tolerances are messed up, maybe with ABS shrinkage works fine. I broke one of the pins trying to open It and had to reprint the cylinder with 0.3mm reducción in diameter. Also I had to trim the edges of all pins to allow closing/opening. My outlets are 82mmx82mm so the fit is very loose, but I could fix It with a thick double side glue tape.

Satisfying model, printed the one with extra weight in the hope for a larger gradient change but this filament is so subtle.

Fantastic details and flawless design

Top layers are a bit rough but very interesting model nonetheless.

Very nice model, thank you. It was very challenging to get it work with CF texture, the 90⁰ angles on the first layer never adhere well. The mechanism is a bit stiff even with lubricant but I trust it will get softer over time.

The best fidget I printed. Unfortunately it didn't catch much texture from the plate but still amazing. Printed in Bambulab Blue Silk PLA.

Worked out ok, the top layer shows some strange diagonal lines but maybe it's just my printer problem. I added some rods that just fit so screws aren't necessary.

Mesmerising, amazing effect of light reflections

The details on the spider part are amazing

I love this model. Printing wasn't perfect in some difficult areas like the dragons' chins or the wings but still looking quite good. Supports are easy to remove.

Flawless and stunning

Excellent