Use this profile to print PETG-Translucent and it turned out really well. Everything was smooth and fit together well. Only downside is that the caps to the silica holder is built for TPU and it doesn't seem like there was a good way to print a non-TPU variant. But this profile worked perfectly

Printed this in PETG HF, I was so amazed at the quality of the outcome. The tolerances are so good and everything fit, snapped, and rotated as it was meant to. I wish all bearings had this kind of performance.

printed great. sliced a version with PLA silk, glow, and basic. extremely satisfying to fidget with.

Great Print, highly functional. easy to get plates in and out.

Great print, messed up by printing first layer PLA Matte and the rest in Silk, the matte stuck so well to the supertack that it one broke while removing the print. Did again with silk first and then matte, worked like a charm. So much fun to fidget with.

printed ok, expect I used PLA Matte on a 3D effect sheet so there was a bunch of areas on the initial layer that didn't melt together correctly. Functionally it worked fine, probably just pass on the effect sheet.