Printed in PETG HF from Bambulabs. Splitting the model in half was great, decided against gluing the two sides together because I couldn’t get the faces to perfectly match up… but where they are positioned in my home the back of them doesn’t matter as much. Fantastic home decor, thanks!

Printed multiple times... this was a fun one, had to really tune in my filament to get the overhang to print with minimal issues. Very nice model, that works extremely well. I scaled it down to 70% to fit about ~20 grams of coffee beans, as it was too large at the original size for my use case!

Printed this in Elegoo Black PLA+, and it came out wonderfully. The articulation is amazing, and it moved straight off the print bed. The print profile settings were great, and had 0 issues with the print!

I was able to quickly and efficiently mount the hygrometers and stick them in my dry boxes. It is really nice to be able to see at a glance that the silica beads are doing their work and keeping my filaments bone dry.

Ordered a bunch of Sunlu/Elegoo/Deeplee filament, and wanted to protect my AMS from the rough cardboard edges. I printed using PETG so that I could throw the filament into my dryer without worrying about the temperature melting the rings. These printed quickly and cleanly. Snap on pretty tight, I haven't seen any issues with it sliding.

Printed a bunch of these in PETG, so that I could use them on my PETG filament rolls without worrying about them getting soft while they sit in my spool dryer. And off course in PLA for my PLA spools. These are great! Holds the filament well, and gives it a nice clean look. The AMS compatibility is a huge plus point because now I am not losing filament clips when I load them up.