Search models, users, collections, and posts
Achievements
Stellar Reviewer
Rate or Comment 293 different models
Pioneer Maker
Print successful 276 different models and 1,987 hours
MakerWorld Guardian
This badge has expired
I purchased a soft enclosure for my A1. There was no way to guide the PTFE tubes from the AMS into the enclosure, so I made one.
Just locate the perfect position on a wall of the enclosure, poke 4 holes for the screws place one plate from the outside, the other from inside of the enclosure and screw them together. After tighten all up, cut out the inner circle with a scalpel, or knife. The rings prevent the cloth of the enclosure from ripping appart.
PTFE tube / cable guide printer housing enclosure
2
6
Share
0
0
0
Ein Muss für alle Nordseefans
Der Toilettenpapierhalter in Form des berühmten ostfriesischen Wahrzeichens, dem Pilsumer Leuchtturm, ebenfalls bekannt aus den Filmen von Otto Waalkes.
Gedruckt in 4 Farben, Gelb, Rot, Schwarz und in meinem Falle Transparent als Fensterglas und Sockel, welches auch durch weiss ersetzt werden kann
roll holder Lighthouse Pilsum Ostfriesland
2
2
Share
0
0
0
Decorative rear mirror hanger in shape of the little tree and the logo of the German Rednecks and Diesel scent (does more smell like DEF :D). Slighly taller then the origin, because size matters.
German Rednecks Wunderbaum Diesel 04 nozzle
20
22
Share
0
0
0
Decorative rear mirror hanger in shape of the little tree and the logo of the German Rednecks and Diesel scent (does more smell like DEF :D). Slighly taller then the origin, because size matters
German Rednecks Wunderbaum Diesel
27
47
Share
1
0
0
I´ve done a remix of https://makerworld.com/en/models/883661-filament-hub-quick-release-a1-a1-mini#profileId-863900 with a surrounding stabilizer and a stabilized slider. The OE version worked fine, but my HUB was leaning slighly backwards, what caused some problems while filament change.
The 3mf has supports, wich are needed. Recommended material is PETG
AMS Lite HUB Stabilizer Quick Release / Change
23
40
Share
0
0
0
I´ve printed the amazing A1 Mini Base (https://makerworld.com/en/models/617618) and to add something to give the spool under the printer a little less friction, I created a hub with a plate, for the spool to rest on.
Spool holder / plate for Bambu Lab A1 Mini Base
1
3
Share
0
0
0
I´ve printed the amazing A1 Mini Base (https://makerworld.com/en/models/617618). It´s great, but the guidung of the filament wasn´t the way I liked it. So i created a inlay for the back legs of the base and a bigger spool
Bambu Lab A1 Mini Base Filament Guide Insert
23
58
Share
0
0
0
I´ve printet the wreath for my living room table. To be able to adapt a few LED candles to it, I edited the 1x1 round plate (6141) and transformed it into a candle holder.
LEG0 Design Candle Holder For Brick Wreath
19
62
Share
0
0
0
No more data