A way to protect your fiddly bits from the outside. This essentially makes the frame longer and gives more room by pushing the camera mount forward.

I really wanted to protect the flight controller from wet grass etc so the side plates were a must. The rest is just little improvements I've settled on in the last few months. I've put a ton of time into making these parts, a boost is appreciated!

RX range was bad so I wanted a normal ELRS module with external antenna and I like standard size GoPro mounts because I can easily switch to full size quads and everything is compatible.

To organize my cords and charge bricks.

A simple upgrade from TPU to get a proper antenna mount.

A simple solution for a small problem but if it helps someone else that's what really matters. Boost if you found it useful.

My mom's cat would turn on the faucet and sometimes spin it around so that it wasn't going into the sink. This prevents that.

This to keep my parents house from flooding due to cat activities.

Just a silly idea that works ok to experiment with this camera.

I wanted to mount a thermal optic for which I made a GoPro pattern housing.

I did this in order to put a GoPro mount on the front where the GPS currently sits.

It's a box label, simple as.

I just needed a simple way to mount a GPS and the back of this quad is already pretty busy.

I wanted to be able to mount a bigger camera!