davidrumm66

MEAF designs

Easy to print and fun to make!Perfect for your candy table, coffee table or any corner of your house&nbsp;&nbsp;Specially designed to fit in the buildplate of any mid size printer.The base is one piece. and every letter and details are separated files so you can print it in different colors even without an AMS.&nbsp;Designed two styles for every “O”. so you can choose what you like.<ul><li>First "O": choose between santa claus or tree ornament</li><li>Second “O”: choose between snowman face or snowman body</li><li>Third “O”: choose between reindeer or christmas elf</li></ul><figure class="image image_resized" style="width:50%;"><img src="https://makerworld.bblmw.com/makerworld/user/1795494732/draft/2023-09-02_n84evi4tipld.gif"></figure>&nbsp;split the "Details" file in to parts with your slicer and just print the details you like for each one and glue them on top!<figure class="image image_resized" style="width:50%;"><img src="https://makerworld.bblmw.com/makerworld/user/1795494732/draft/2023-09-02_o1xtzxx4tz4i.png"></figure>&nbsp;&nbsp;&nbsp;Print SettingsMaterial: PLA / PETGLayer height: 0,28 mm for letters and base. --- 0.2 for detailsNozzle diameter: 0,4mm or 0,6mmInfill: 10 -12%Perimeters: 2Supports: no&nbsp;Printing Tipthe tolerances are a little tight, so you will need some glue depending on your printer and/or filament calibration&nbsp;&nbsp;&nbsp;

Christmas hohoho Sign

Christmas

Ken Mills

The normal size has a 160mm internal (max roll size) and 32mm post diameter (max hole size). The medium and small sizes are 140mm and 114mm respectively. The jumbo version has a 180mm internal and 38mm post diameter to accommodate larger rolls.&nbsp;After adding the towel roll with the end free, spinning the roll clockwise should automatically feed the end out of the side slot. Tear a sheet off by pulling from the bottom upward and towards the right edge of the slot.&nbsp;Feel free to increase the holder's height. I chose 180mm high to fit my bed, and I don't think I would go much shorted, but I think taller wouldn't hurt.&nbsp;Add three rubber pads or feet to help prevent sliding. I have a spot on my workbench paper towels live, so I just may attach it with some double-sided tape to create a semi-permanent home for a roll.

Spiral Vertical Paper Towel Holder

Household

m.cody.sims

Just a good Mando helmet!&nbsp;My profile doesn&#39;t have support on the inside of the helmet because I have found it didn&#39;t really help that much with the quality and it used a lot of filament. the very center of the inside will be rough because of this but it hasn&#39;t been an issue for me.&nbsp;For those wondering what I use for a face sheild I use a Hobart 770580 Face Shield Replacement Lens, Shaded from Amazon. I cut it to shape and use a little bit of hot glue along the front and near the temples. That seems to be enough. I would recommend getting air soft helmet padding for a custom fit and comfort.&nbsp;If you like my work, please consider supporting me by boosting my model or <a target="_blank" href="https://www.buymeacoffee.com/m.cody.sims" rel="nofollow noopener">buying me a coffee</a>!

bus

Christmas

Household

Cosplay