Anansi

KYZ Design

After watching standard 1x1 bins print infill layer after infill layer that could have been used for storage, this is one of the first 3D print models I've designed. I've since refined it, with the following features:<ul><li>0.84mm thick walls - a 0.4mm nozzle will do this in 2 passes</li><li>0.75mm thick base - designed for 3 layers of 0.25mm (but prints fine with 0.20mm layers)</li><li>Label shelf versions have 7mm wide label areas designed for 6mm wide labels</li><li>No magnet holes</li><li>Changes to fillets and chamfers</li><li>Other minor changes</li></ul>It is highly recommended to print 2 more at a time for a more consistent outer wall surface gloss. With just one bin, you might see that some sections are more glossy than others due to your filament profile's layer time limitations.&nbsp;Check out <a target="_blank" href="https://makerworld.com/en/u/11128021/collections/26498" rel="nofollow noopener">this collection</a> for my other Gridfinity models andcheck out <a target="_blank" href="https://makerworld.com/en/u/11128021/collections/18964" rel="nofollow noopener">this collection</a> for my other Honeycomb Storage Wall models.

Gridfinity Deep 1x1 Divider Bins

sort shit

3DPrintWell.co.uk

Push the spaghetti through the hole and BRRRRRT!

Spaghetti Gun! - it shoots Spaghetti!

Funny stuff

Northern Printworks

A simple little addition to add to the top of your A1/A1 Mini toolhead to allow easier removal of the Bowden tubes on hotend side if you have an AMS. These little suckers are difficult to get pressed with fingers so this tool allows you to press towards what corner you want then wiggle the tube to come out. The holes are large enough to not interfere with the Bowden tubes and toolhead movements. Check my other prints to find the A1 Bowden tube supports and the release tool for the AMS side of the A1/A1 Mini. How to use: Place your thumb under the toolhead (Make sure not hot), then use your other 2 fingers to press straight down on the releaser. Then simply use your other hand to wiggle the tube out. <img src="https://makerworld.bblmw.com/makerworld/draft/281482/2023-12-17_883d71cdb2182.gif">&nbsp;&nbsp;A1 Bowden Tube Supports:<a target="_blank" href="https://makerworld.com/en/models/78732#profileId-83046" rel="nofollow noopener">https://makerworld.com/en/models/78732#profileId-83046</a>A1 Bowden Tube Release Tool AMS Side: <a target="_blank" href="https://makerworld.com/en/models/78741#profileId-83050" rel="nofollow noopener">https://makerworld.com/en/models/78741#profileId-83050</a>&nbsp;

sort shit

Funny stuff

A1 upgrades