DanTheMan

I had to redesign my 100 pcs hex bit holder for a number of reasons.&nbsp;<ol><li>It was very hard to pull out any bits located in the middle.</li><li>The dimensions were different from filament to filament.</li><li>I had to add an handle, to be able to pull a tray out, if it located in the stacker.</li></ol>&nbsp;What did i change?<ol><li>obviously i changed the amount of hex bits from 100 to 66 (8 x 8)</li><li>I made the design thinner, using less filament.</li><li>I made the hole for the hex bits just a little bigger, which should make it much easier to insert and pull out hex bits.</li></ol>If you run into dimension issues, scale the design on the X and Y axis.

Simple Hex Bit 64 pcs holder with handle

Hex Bit holder & stacker v2

I needed to create a lid for my stacker.&nbsp;This lid is basically just the “stacker” part, without the pillars.&nbsp;Can be printed without supports.

Hex Bit holder & stacker v2

Hex Bit holder with stacker