dannyL

3D servis

3DBenchy is a 3D model specifically designed for testing and benchmarking 3D printers

3D BENCHY 2024

some prints to print

3DMN

Remember if you sant to scale, do it only with x and y axis, z must be the same as original. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmFilaments Used: PETG JAYO Black Transmission Distance: 0.3 PETG JAYO Gray Transmission Distance: 2.5 PETG GEETECH Gray Transmission Distance: 3 PETG JAYO White Transmission Distance: 6Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Gray At layer #12 (1.04mm) swap to Gray At layer #18 (1.52mm) swap to White for the rest.

Tiger (hueforge)

models 4 frens

OldViking

The spool holder has to be rotated 50 degrease to fit the print aera in Bambu Lab P1S.(As a precaution both holder parts should be rotated 50 degrease to be sure that they match each other).&nbsp;Plotprofil: Bambu PLA Basic Preset: 0.20mm Strength @BBL X1C - Wall loops: 6 - Sparse infil: 25% Grid Bolts required: 4 x M3 20 mm thread + bolt head 2 mm high 2 x M3 12 mm thread + bolt head 2 mm highNuts required: 2 x M3 5,4 mm wide&nbsp;Design: Søren Håkan November 2023Copyright notes: Not for Commercial Use - Created in Autodesk Fusion 360 Personal

BambuLab P1S -Top Spool Holder

practical models

Hamstah

Print-in-place planetary gear spinner. Spins freely straight off the plate.&nbsp;I set up two print profiles for this model: Heavy outer ring - prints using 43g of filament to make the outer ring heavier. This gives it a bit more inertia, but feels heavier in the hand.Light outer ring - prints using 29g of filament. Feels lightweight in the hand and prints faster, but doesn't have as much inertia.&nbsp;Both spin great - I'd say pick the print profile based on how you want it to feel in the hand.

some prints to print

models 4 frens

practical models

fidgets to print