dadle

jayburd

I have tried various splitter designs and none worked as reliably as I would have liked. This design utilizes the A1 AMS Lite Filament Hub ($6) sold on Bambu store as the splitter for AMS and external spool. As such, you end up with 4 usable inputs.&nbsp;The model is the splitter holder. It can be attached to the printer body using M3x6mm or M3x8mm screw. The A1 filament hub should sit snugly in the holder but with some play. The single tube side of the hub plugs into the PTFE connector as if it is a PTFE tube, it is a little tight so push it in as far as you can. &nbsp;In my testing, this has performed flawlessly. It would not be surprising as this design uses the OEM part that's designed specifically for the same purpose of multiplexing multiple filament input into one.&nbsp;Update: <a target="_blank" href="https://makerworld.com/en/models/35839#profileId-48557" rel="nofollow noopener">New angled holder</a> added based on feedback from <a target="_blank" href="https://makerworld.com/en/u/2841498950" rel="nofollow noopener">@BenjDavison90</a>. Listed as second print profile&nbsp;Update: revised the angled holder based on feedback from <a target="_blank" href="https://makerworld.com/en/u/2841498950" rel="nofollow noopener">@BenjDavison90</a>. Thanks again Ben&nbsp;Update Oct 26: added new print profile Straight V2, this version has two screw holes for mounting to the upper right corner of the rear panel of P1P, P1S, X1C&nbsp;To purchase the A1 AMS Lite Filament Hub (shown in the second picture)US: <a target="_blank" href="https://us.store.bambulab.com/products/ams-lite-filament-hub" rel="nofollow noopener">https://us.store.bambulab.com/products/ams-lite-filament-hub</a>EU: <a target="_blank" href="https://eu.store.bambulab.com/products/ams-lite-filament-hub?skr=yes" rel="nofollow noopener">https://eu.store.bambulab.com/products/ams-lite-filament-hub?skr=yes</a>UK: <a target="_blank" href="https://uk.store.bambulab.com/products/ams-lite-filament-hub?skr=yes" rel="nofollow noopener">https://uk.store.bambulab.com/products/ams-lite-filament-hub?skr=yes</a>&nbsp;

Bambu AMS External Spool Y Splitter using A1 Filament Hub

3d print

giacomocarmelo

Bubble vase stampato in Pla, alto 15cm, larghezza foro 10,5cm, lcirconferenza più esterna 14,5cm, spessore 3mm.&nbsp;Bubble vase printed in Pla, 15cm high, hole width 10.5cm, outermost circumference 14.5cm, thickness 3mm

Bubble Vase/Caterpillar Vase

darila

diegofesti

Clip per fissare cavo Festool al tubo festool con diametro crescente. Le clip sono da 33 / 36 / 39.Ho scritto sulla superfice la grandezza per distinguerle sul piatto, in fase di stampa è appena visibile.Stampate con infill 100%, ho disegnato questa versione perchè non sevano supporti.Buona aspirazione!