Nice snug fit on the board. I don’t have to worry about pulling it off the board when removing the ruler. And if anyone is interested in the model I created shown next to it, here’s a shameless plug. 😅 https://makerworld.com/en/models/1465708-40mm-vacuum-bag-disc-holder-for-skadis#profileId-1528994

I found the tolerances are too tight to fit. But after snapping off two of the arms, the remaining arm works perfectly without trapping beans like it did when I tried to bend the arms down so it would fit.

Excellent model. Printed in PETG. I should have dried my filament prior to printing to reduce defects but nothing catastrophic or the fault of the model or print profile. I had seen review prior to printing saying assembly was confusing but maybe they were old because I printed the latest version and found it really straight forward and enjoyable.

customised to 40mm to better suit my electic pump. Works exactly as advertised. Very happy!

worked exactly as advertised! very happy!

great print. my only minor quibble is the latches are tricky to get a grip on and open. but may I just have fat fingers. 😅