criedel_50

bdwilson

This is a very quick way to calculate your flow ratio for new filament. It takes about 5 minutes to print two pieces at normal speed. The Print Profile includes the following settings: 0% infill and 1.2mm shell thickness (3 shells) for 0.4mm nozzle. Wait for them to cool down before removing them as you don't want to flex them when removing from build pate. If you do not own calipers, you can quickly gauge current accuracy of your flow rate by connecting both pieces together and if your flow rate is close, they should fit together loosely so that connecting one piece to the other is snug but not tight. If it's a tight fit, there is some work to do (keep reading).&nbsp;Once you've removed them from the build plate, use the Google Sheet (<a target="_blank" href="https://goo.gl/kbuZMi" rel="nofollow noopener">here</a>) and follow the instructions. Make sure you input your starting flow rate for your specific filament if you did not already set it to 1.0. Use the calipers and perform at least 3 measurements on each of the pieces - don't forget to flip them over to measure as well. Use this information to calculate your new flow rate. That's it - no need to adjust your diameter or density - just adjust the flow rate and you're done! &nbsp;Original credit goes to nirdobovizki for the original work.

Fast Extrusion Calibration Test for Calculating Filament Flow Rate

test

MottN.

These fit 3/8&#34; drive metric Impact socket sets. These will hopefully work for you if you have a set that matches one of the combinations below. Note that normal sockets and impact sockets have different dimensions; if you are looking for normal sockets I have a separate model posted for those.<ul><li>10pc: 10, 11, 12, 13, 14, 15, 16, 17, 18, 19</li><li>11pc: 8, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19</li><li>12pc: 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19</li><li>13pc set 1: 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19</li><li>13pc set 2: 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 21</li><li>14p: 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 21</li></ul>In the print profile pick the set or sets you want to print and whether you want the left or right hand labeled version. Color change is at layer 91 with the standard 0.28mm extra draft profile, or use the profile I uploaded.&nbsp;Check the hole sizes by either by measuring hole sizes or move the blocks partway through the build plate (so the first layer has the holes in it) and print just a couple layers.&nbsp;If these don&#39;t work for you you can make something similarly sized for your specific sets with the parametric files <a target="_blank" href="https://makerworld.com/en/models/477335#profileId-388377" rel="nofollow noopener">here</a>&nbsp;The bottom is 21mm gridfinty squares which are compatible with the standard 42mm grid.

test

tool organization