Shoff3dprints

electrical meme

Tiny Little Disk Shooter Ext Mag

The Weiner Plug

mounting hook with holes

jeep cup holder phone holder

works amazing! Easy assembly, and well thought out design. I have one question tho, can you make an extension mag? I found that a pla spring and pla ammo works best. Hope this helps! 

StatusSymbol

Tiny Little Disc Shooter - x4 - Fully 3d printable

0.2mm layer, 2 walls, 15% infill

It printed smoothly. After removing the supports I installed the motor which I had grabbed from an old drone. Then I grabbed a switch, wires, and the two ends of a battery case and soldered it all. I then proceeded to cut a hole into the front of my plane to make room for the battery and switch. Then I hot glued everything in place and put tape over the wires to hide them. For the propeller I took an old propeller from my drone and trimmed it down so it would fit. The plane flys great! Thanks :)

Slimis

foam glider plane motor mount

0.12mm layer, 2 walls, 15% infill

looks good and does its job. I used a hairdryer to make the plastic malleable and bent it up against the existing plastic because my switch cover is slightly curved. 