cmoss

ironspork

A 3x3 printable gridfinity insert that holds the basic X1C stuff.

Gridfinity Bambu X1C Basic tools

Gridfinity

Fathomkat

<h3>Print instructions</h3><ul><li>No supports</li><li>Print cap upside down</li><li>0,3mm layers work well</li><li>Detect bridging perimeters</li></ul>

Silica gel spool container 

First Prints

DesignCraft

DISCLAIMER: Print profiles NOT created by DesignCraft may contain outdated model versions or suboptimal slicer settings. Use at your own risk! I have no control to moderate or remove these third party print profiles.&nbsp;The Sunlu v2 print profiles include the latest models for this adapter system. The models have been updated to include the <a target="_blank" href="https://amzn.to/3QIOVEk" rel="nofollow noopener">SUNLU</a> nameplate and also reduce the amount of material needed for each print. Please refer to the Disclaimer above and also please read the Considerations section below.&nbsp;Description:<ul><li>This model widens one side of the spool ring adapter to stabilize a SUNLU 1kg 195x60mm spool while it rotates within a Bambu Lab AMS. </li><li>I've tested these adapters on SUNLU PLA and SUNLU PLA Meta spools. I have not tested on SUNLU PLA+ and some people have reported that the PLA+ spools are larger. Please measure your spool before printing.</li></ul>Instructions:<ul><li>Print one of each model for a single spool.</li><li>Affix the wide spool ring adapter on the right-hand side of the SUNLU spool if you're facing the AMS.</li><li>See attached photos.</li></ul>Considerations:<ul><li>Print Material: Please print with a basic PLA or PETG to minimize any shrinkage.</li></ul>

Gridfinity

First Prints

Filament