Wonderful design. Thank you for sharing. It would be nice to have a version without the name of the school.

Tolerances are perfect. Good print profile.

Absolutely stunning. Tahnks for sharing.

Beautiful design, thanks for sharing! If anyone is curious about using a printed bearing. I used this 608 bearing by Tassesin in PETG: https://makerworld.com/en/models/473167-608z-6000z-roller-bearing-v2#profileId-383170

Looks neat and sounds creepy! Supports came off easy too. Thanks for sharing.

Printed this to find out what Hueforge is all about and am truly impressed.

Looks and works great! Thanks for sharing. The design is a bit bulky though, I wonder if there is a way to slim it down a bit.

This design is a lot of fun! It's truly impressive that this is a print in place model. Thank you for sharing. I printed in Suu matte black and blue glow in the dark Pla. I find it a bit counter intuitive to have to push the key into the launcher as opposed to pulling it out to get the blade to launch. I think some arrows indicating the proper usage could help.

Print was good but the design over all doesn't offer much more benefit than just using the corner of a counter to squeeze out the toothpaste.

Tryly impressive design. Thank you for sharing! As others have said I had some issues with the gears not spinnjng. But as the designer mentioned using some silicone lubricant did the trick. I used WD-40 Specialist Dirt & Dust Resistant Dry Lube. It's now launching the blade fast and far. I think it would be beneficial to add arrows on the top of the launcher as well, not only the bottom. It's a bit inconvenient to have to flip over the machine every time to know which way to spin it.

Absolutely wonderful! Thank you for creating this and for sharing.

As others mentioned with the supports it leaves a little residue behind but it auprianhlu doesn't affect the balls ability to roll around. Thanks for sharing!

Beauty! Print and fit is prefect. I find getting the ends of the cables to align perfectly with the slots takes smallest amount of practice. But after wrapping it around two or three times it becomes easier. Off to print as many as my build plate can handle.

Perfect fit!

Nice solution to a very common problem. Thanks for sharing.

The model and print work perfectly! Thanks for sharing!

Nice model and good print. I only realized after that there was a V4 so I used that instead.

Looks and sounds great! Thanks for sharing.

Looks great and the fit is perfect. The click when it closes is very satisfying. Thanks for sharing.