chrisjniles

Apple TV 4K Remote with charging and siri cutouts

Great print! My wife wanted a little vase for some lego flowers that I bought her and this was perfect. I scaled it down to be 100 mm tall in BambuStudio

Bloomly

Vase with Roses and Stems - Flowers Bouquet

Thick Vase

It turned out great! I printed in silver BambuLab PLA basic to match the crank.

InstantCassette

Playdate Stand

0.16mm layer, 2 walls, 15% infill

Printed in purple Inland PETG (from MicroCenter). Apparently I need to dry my filament as I got some stringing and prominent layer lines, but that's not the print profile's fault. The first time I printed (flat on the print bed) one of the support snapped off as a layer line, so I reoriented the print at an angle and printed with supports. It's perfect for what I needed.

TomTech3DX

Halter für TP Link SG108

Holder for TP Link SG108

0.2mm layer, 2 walls, 15% infill, bohrungen verstärkt

0.2mm layer, 2 walls, 15% infill, reinforced holes

I printed it in purple Inland PETG to hold some family devices. It's fastened to the desk using 3M command strips on one side. Also, I think I need to dry my filament as I got some stringing and odd layer lines, but that's not the print profile's fault.