Printed fine and looked great, until I tried to attach the sensor part. The pegs snapped off immediately.

Exceptional quality. Printed perfectly with no changing of settings. Wife is please theres somewhere for them all to go. Boosted x 2.

Love it. Been collecting turds from my A1 and then P2S for the last 18 months. Only just had enough.

Difficult to slot together. Used a pin hammer in the end and then dropped it, bit fell off but glued back on ok.

Came out well. Some banding but I think thats the filament.

Came out nice in elegoo white silk and bbl candy red silk.

Printed great. Daughter is going to love them on her tree.

Had to trim them down a bit to fit. But I printed the large size like a clown.

Perfect for my daughters room. She loves her google mini now.

Love it. Keeps my rechargeable and non rechargeable batteries together. Just need some top covers now.

Excellent design. Printed in PLA and one wing piece off a ring snapped but thats fine. Some parts go together loose and some stiff. Again not an issue. My main difficulty was putting wires in vertically. It kept sliding down and then spinning round for the loose connections. I've not managed to tidy all of the cables because itit'boiling hot here in the UK and the 29 degree C room was getting too much.

Printed perfectly. Been sat on my windowsill holding my Sony headphones. Printed in eSun marble PLA.My only improvement would be holes in the base to glue pennies in, with a pause in the print. I've seen this before but my skills are not quite there to do this mod myself.