printed excellently just what I needed for my engraver

great design only issue is top plates pops off every time I pull a bit out ended up having to glue it down

not sure if I use the wrong magnets but my magnets wanted to sink in very deep. still works great though

excellent design other than supports filling the hole for the screws. also could be a little less filament used.

great looking print. only issue I have is does not weigh enough. ended up reprinting and pausing halfway through to add pieces of metal inside a chamber I made to give it enough weight and not get knocked over

print it out awesome way better than my design

a pretty nice print. only issue is the screen that goes on before the AMS door is pretty thin. also had some issues getting it to sit in the AMS slot had to put some pressure to get it to click all the way in. there may be some small clearance issues but overall works out very well we'll see how it is to remove when the beads need replacing

great print but a bit loose in the board

love it works great have three in my office.