Fits great! I was disappointed I had a caulk tube that didn’t have a screw-on cap, and was worried it would dry out after initial use, but this print allowed me to still cap the tube!

Fits great! Exactly what I needed.

I do wish the feet were a bit wider in the Z axis direction so that the stick figure could stand better. But otherwise, it is great!

This was absolutely incredible! I Was shocked at just how much like fabric it turned out. Very flexible and such a fun print to celebrate the Olympics.

Holds up against the weight of the flags.

My wife and I love Friends and this was a fun little Valentine’s surprise. They came out great, though the arms are a little stiff.

I printed two - the first one didn’t print super well, but I am almost positive that was due to my filament, not the print profile. The second one I printed came out much better.

I printed this as a container for articulating snakes that I printed for my son. This works great! The screw thread did start to peel a little bit after my toddler smashed the halves together several times, but otherwise it has held up well against rough play. At first, the halves were tough to screw together, but it gets easier over time.

My son absolutely loves these snakes! I printed them in several different colors. They’re a great fidget toy too!

Unfortuantely, the male screw thread broke while I was trying to remove the supports. I haven’t gotten around to re-printing it yet. UPDATE - sounds like I just needed to unscrew the support rather than pulling it off. I’ll have to try that next time I print it.

this seriously saved me so much time while glueing!

I wish the imprint was a little deeper, Sometimes it is hard to get a really good imprint because the lines don’t imprint deep enough.

it printed great, though I wish the logo was deeper into the lid, because I printed the lid in black with the logo and white, and you can see the black coloring through it a little bit

It assembled great, but I wish I had printed it with a 0.2 mm nozzle. The numbers didn’t turn out super clear with a 0.4 mm nozzle. Also, when turning the dials, some of the numbers get stuck in the openings and you have to fiddle with it to get it to continue turning.

This was my very first TPU print, and I think it turned out great! Fair warning, TPU can be extremely difficult to get off of a textured PEI plate unless you use glue or some other substance to make it easier to separate. That is more of a commentary on my inexperience with TPU than this actual print. As far as this print goes, it works as intended! Definitely keeps the knobs from turning. Thanks to the TPU, so far it has stood up well against heat and bending. My wife accidentally closed the edge of one of these in the oven door while making dinner (our stove knobs are quite close to the edge of the door). After we were done with dinner, she noticed that it had been closed in the door. It was quite bent and had been very hot, But it very quickly returned to its original shape!

Fits great with the box I already printed. The detail on the imperial lid is incredible! When I went to print this, I didn’t realize how many lids there were to choose from. The picture only shows two, but there are actually seven build plates to choose from!

Works like a charm! I am often switching between a 0.2 mm and a 0.4 mm nozzle. This tool helps that switch go much quicker!