I’m wishing there was some sort of way I could publish models I have made in ‘beta’ - ie. without me having to print them first. I made some models recently that are shelves/clips that clip onto a 19mm tent pole, I chose 19mm because that’s what size I needed personally. But tent pole sizes vary, 16mm and 22mm are also widely used, and it is very easy for me to modify several of my designs to suit the different sizes. But the issue is - I personally I have no need for these sizes, if I printed the models myself to test them I would be just be wasting my filament creating something I can’t use and would just get thrown away. So the result end up being I simply don’t publish those other models. It would be great that where you click the box that says you tested the print profile - you could instead tick that the model is in BETA mode and you need community testers to confirm the print profile on my behalf. Then just display a warning message etc, and nicely ask the user for photo & confirmation print was okay. For me this would allow me to release quite a few variations of models I never would have published otherwise.