brianclarkms

DWdesigns

This is a tool to help release the PTFE tube from the filament buffer on the back, and from the extruder (printhead). &nbsp;Inevitably, one will run into filament feeding problems. This usually requires releasing the PTFE tube from the back of the filament buffer, and sometimes the PTFE tube from the extruder, among other steps. This tool can help to release the tube from both places. &nbsp;Releasing the PTFE tube requires one to push down on a ring that's securing the PTFE tube. In the filament buffer in the back of the printer, the ring is recessed inside and not easy to get to. This tool can push down on the ring without having to open up the buffer.&nbsp;This tool also allows one to press down on the ring on the extruder to release the PTFE tube without opening the extruder (printhead) cover.&nbsp;An ergonomic handle design and finger grip pattern make it easy to use. The handle is long to make it easier to reach and get to the filament buffer in the back of the printer.&nbsp;Easy to print, no support, no brim.

PTFE tube release tool for the filament buffer and extruder

tools

raphratz

I wanted to mount a some Skadis boards at the side of my printer. If found the original model by <a target="_blank" href="https://www.printables.com/de/@hairyfacedhooman" rel="nofollow noopener">hairyfacedhooman</a> but wasn't 100% with that.I added a little spacer, so it fits with my AMS riser. In addition I added some hooks, because I printed the Skadis boards myself and therefore didn't have the original mounting hardware.The uploaded model is for mounting on the right side of the AMS. I haven't tested the left side, but I'm very sure, that the model just needs to be mirrored and should work then.I also haven't tested with the older version of the AMS, but as far as I know it shouldn't work there.Be careful when removing the supports from the hooks, they tend to break off.

tools

skadis