benjamingarciazamora

Porsche 

Papadansmaman

Only a very simple Business Card Holder. No support needed! p.s. Can be use as a Phone holder too ;) P.s.2. Be sure that the printer is well calibrated and use the brim version profile to have the best result. There is not a lot of contact surface with build plate to have 100% success without the brim.  IMPORTANT: ***Use the brim version profile instead of the original one*** Many of you got fail from this print, It was weird because mine was super clean and sturdy! I found the problem! I got some printing issue since the last update. So printed one holder with the last update and another one with the firmware 01.04.02.00. This is a photo of 2 prints from the same print profile, with the same filament and exactly the same preset! The only difference is the firmware! with the old one I don't have any issue and the business card holder is very sturdy and with the last firm  one side warp and the spaghetti party was on!. The profile with the brim work better with the warpping issue from the last firmware. <img src="https://makerworld.bblmw.com/makerworld/draft/476582/2024-01-29_72a38fc530dc18.jpg">

Porsche

office organizers