bcosmin6

heapstar

It is a 90 x 90 mm cross table for light duty coordinate drilling. You need 2 pce M6 x 1.0 L30 flat point hex socket set screws and 2 pce M5 L45 hex socket screws for clamoing the dove tails to complete.

Cross Table

Workshop

AU3D

Like many others, I greatly appreciate the Phone Stand by Reckit. However, as an AMS user with a preference for convenience, I sought a more efficient solution. This modified version incorporates accent lines, enabling the holder to be printed as a single unit. I've developed five variants, ranging from 0.2 to 1mm in accent line thickness, giving you complete control over the number of filament swaps required. Additionally, I've enhanced the design by increasing the bottom layers to four (up from three) to eliminate any potential shine-through, and expanded the perimeters to three for optimal results with lighter colors. I am very pleased with the outcome.

Smartphone Stand / Holder by Reckit (Remix; no Assembly)

Stuff

Wiseone

The curious discards from the Bambu 3D printer, left unattended, will litter your desk or floor. Here is yet another "poop chute" to divert the filament effluent into an adjacent receptacle.&nbsp;My design consists of two parts, a chute and a bin or "poop tray". The chute catches the filament waste and diverts it into an easier to get to small bin. The design aims to be minimal in print material, yet functional.&nbsp;The chute secures to the back of the Bambu printer via a 3mm x 7mm self-tapping screw. The screw should be enough to retain the chute in position. Otherwise, double sided tape can assist. The bin comes in two sizes (50 and 100mm widths) and sits freely at the base of the chute and captures the waste.&nbsp;With regards to a replacement screw, here's a couple of suggestions from my followers:    1.  If you got your printer with the AMS, the screw that held it to the print bed is the perfect size to hold this in place.    2.  The screws included with your Bambu printer to make up the scraper fit nicely, too.&nbsp;My print is made in 1.75mm Bambu PLA Green filament, with 0.24mm layer height and 15% infill on a Bambu Lab X1 Carbon printer. Print supports are not required.&nbsp;I hope you can find this print useful, too.&nbsp;UPDATE 12/12/2023 Added a 100mm wide poop chute bin.

Workshop

Stuff

Printer accessories