I love the boxes from this user. My only concerns with this print is the weird banding on the top,half and all the wasted space for the lid. Great hinge and love the handle though. And I am a huge fan of the spring latch!

These tools came in clutch, we just moved and it was nice to have a very rapid print that made taking down my printer an effortless task. Highly recommended!

Nice print, infill is overkill though, would have been nicer with less filament and time cost.

Very nice, probably not a fair die, but great print and looks great!

A little small for my hands but fits in the storage case perfectly and is better than not having the handle. Print itself was flawess and effortless to print.

Wow! Just wow! Perfect print, absolutely newbie proof. I even messed up the supports and used the wetest filament I had…even ran out mid print to use an older wetter roll. Still printed as perfect as a day 1 benchy. It folded on the hinge perfectly right as i was taking it off the plate! Best tolerances of any model I have printed so far! I plan on printing more of this designer’s designs and I sincerely hope they make many more. I wish I had a sixth star to give. I consider this a MUST PRINT.

These are my new favorite filament clips! I printed them just to spend out a roll, but I didn’t realize how well they would work! Highly recommended!

Nice print, wish it was parametric or at least mention what coin it is designed for

Fantastic build, color layers could have used one or two more layers to prevent bleed through.

Nice card shoe, but a little too much room, cards fall flat to bottom of shoe. Also the surface has a weird fuzzy texture that made the print take 6x longer than it should have. Did not print player trays, am designing my own.

Very tight tolerance, only half my red discs fit. The set up tokens no longer have a well and was unintuitive how to store. Also does not support vertical storage…apparently.

almost exactly what I needed. i may need to add tpu pads to keep it from sliding as i draw

Fits in the slot fine, didn’t need both lids, both fit fine. Supported area came out a little messy, also was confused at “bulge” on front and sides at first.

way better than I expected, though a little large. printed in petg and surprisingly it didn’t stringify on me! fantastic design job!

MUST PRINT if you have an AMS! Loses a star for a slightly wonky print profile. I love the form and function of this awesome accessory, but the (literal) rough edges are apparent very quickly. The model uses rounded edges instead of filets or chamfers which are tricky to print. The designer chose to support the rounded edge opposed to designing a print friendly surface. This leads to excessive material waste and potential delamination (as evidenced by photos in the thread). TIP FOR PRINTING PLATE 2/SECTION 3: This section has numerous photos showing poor adhesion or delamination. This is a strong sign of improper cooling. If you are using an enclosed printer, rotate the plate 180 degrees to orient that section closer to your printers fan and it will significantly improve (though not totally correct) this issue. Despite the print issues and the over 300g of wasted filament, I do highly recommend this print.

Highly recommend, great print profiles. Works first time.

The first desiccant pods I have found that are practical without being a filament torture test. Printed perfectly and the mesh is perfect for containing desiccant! Highly recommend!

Significantly larger than it needs to be, but it prints and looks great!

nice fit, looks fancy, but a tad larger than it needed to be. also two lids lifted (not a draft, using x1c)