Well bly me! That works. Printed in Bambu PETG-HF. Even snaps on a bit. Might go with micro downsize to fit even better. Thanks, also on behalve of the kittycat :)

Thanks!

Super, thanks!

Helpfull, thanks!

Long live the empire! Thanks :)

Geat! Thanks

Works like a sharm! No more swinging of the pods, fast easy print. Thank you!

👌🏻

Works on Hue white G10, 0.2 0.4 both fine. A bit to big perhaps. Pla+ yellow have to see if it takes the heat. Gonna experiment with a white one or maybe two layers of colour. Thanks for sharing!

👌🏽

Nice! Thanks!

Perfection! Thank you! *boosted*

Printed fine in Bambu ABS black: i was happy to find a print without the thermo sensor. Didn't see the need for it. Printed only a 40% of the parts for now due to the print time. Thank you for sharing you design

Needed it, thank you for sharing the design. Printer fine in Bambu tangerine yellow ABS, did use a wide inside/outside brim to be safe. Snapped off without any scaring. 5/5*

Nice, thanks for sharing!

Perfect! Printed in Bambu Yellow Tangerine ABS Thank you for sharing this print

Handy for bulding my first Cyberbrick project. Thank you for sharing! Used Bambu PLA/PETG support and snapped away supereasy without damage.

Nice! Will re-do because i loaded the wrong green <dôh!>. And the grey, allthough calibrated was lacking a bit infill. Also: no ironing by default. Timewise that didn't add much i believe.

Very handy. Perfect print. Thanks for sharing!